(In config mode) - license boot level license-level ģ750-sw01(config)#license boot level ipservices switch 1ģ750-sw01(config)#license boot level ipservices switch 2 Before reloading the device, the next license boot level of the switch has to be changed, use the following command to do so: Step 4 : The license is installed once you have accepted the EULA, but to enable the feature set after installing the license, you need to reload the device. Once the license gets installed a log message similar to this should be seen: "%IOS_LICENSE_IMAGE_APPLICATION-6-LICENSE_LEVEL: Next reboot level = ipservices and License = ipservices"
#Cisco 3750 ipservices license install
License install file-sys:file-sys//lic-location Step 3 : Install the license on the switch with the following command in the privilege mode: Step 2 : copy license file onto the flash: device from the tftp server. Step 1 : Log in to the switch by using the console port, the Ethernet management port, or a Telnet session. You can run license right-to-use activate ip-services all accepteula to activate ipservices, and then restart the switch. Evaluation licenses Pre-installed on the switch and is valid for only a 90 day in-use period. Index: 5 Feature: ipservices Version: 1.0 Permanent licenses Purchased with a specific feature set with no expiration date. Index: 4 Feature: ipservices Version: 1.0
#Cisco 3750 ipservices license how to
Here switch 3 means Stack 3, Can you address me how to configure the and post configuration, have to reboot it ? The master switch specifies "Next reload license Level: ipservices" and the stack member specifies "Next reboot licensing Level: ipbase".I thought both switch should specify "Next relaod license level:ipservices".Ĭisco IOS Software, C3750E Software (C3750E-UNIVERSALK9-M), Version 15.0(2)SE10, RELEASE SOFTWARE (fc2)
After executing the commands i did "sh ver". IP Base License: Cisco Catalyst 3560-X and 3750-X Series Switches Dynamic routing provides network scalability, adaptability and resiliency. Here, I’ll concentrate on the layer 3 switching capabilities of the Cisco Catalyst 3560-X and Catalyst 3750-X switches. So as i mentioned before i used the commands " license boot level ipservices switch 1" and "license boot level ipservices switch 2" on the master switch. Layer 3 switching and routing are so close that they spark lots of. Now I need to upgrade the license from "Ipbase" to "ipservice". License State: Active, Not in Use, EULA not accepted License State: Active, Not in Use, EULA accepted The IP Base image feature set includes advanced quality of service (QoS), rate-limiting, access control lists (ACLs), static routing, Routing Information Protocol (RIP) and EIGRP stub routing, capabilities. Index: 2 Feature: ipservices Version: 1.0 The Cisco Catalyst 3750 Series is available with either the IP Base image or the IP Services image.